[Seaside] VW 2.5b3.6.0 configuring new application problem
Roger Whitney
whitney at cs.sdsu.edu
Wed Sep 15 22:26:31 CEST 2004
Michel,
No message in the Transcript when I create the new entry point nor
when I try to access it without running 'AAADocumentation new
createWebSite' . When I run 'AAADocumentation new createWebSite' no
output. However when I then access the new entry point after that I get
in the Transcript:
init
Seaside alternate servlet ready
Seaside alternate dispatcher enabled on path /seaside/go/
and all is then fine.
On Sep 15, 2004, at 1:08 PM, Michel Bany wrote:
> Roger Whitney a écrit :
>
>> I am having some problem configuring new applications in the VW
>> 2.5b3.6.0 version of Seaside running in VW 7.2.1. I can go to the
>> config page (http://localhost:XXXX/seaside/go/config) and add a new
>> entry point. The entry point will show on the list of entry points on
>> the config page. However, I can not access the new entry point. I get
>> a page saying 'Error: "/seaside/go/newEntryPoint" not found'. Once I
>> run 'AAADocumentation new createWebSite' I can access the new
>> location. Anyone else having this problem?
>>
> Any message in the Transcript ?
>
> Michel.
> _______________________________________________
> Seaside mailing list
> Seaside at lists.squeakfoundation.org
> http://lists.squeakfoundation.org/listinfo/seaside
>
>
----
Roger Whitney Department of Computer Science
whitney at cs.sdsu.edu San Diego State University
http://www.eli.sdsu.edu/ San Diego, CA 92182-7720
(619) 583-1978
(619) 594-3535 (office)
(619) 594-6746 (fax)
More information about the Seaside
mailing list