[Seaside] Seaside not loading css styles (but our fault)

[Lukas Renggli]

On 23 September 2011 11:50, Mariano Martinez Peck <marianopeck at gmail.com> wrote:
>
>
> On Fri, Sep 23, 2011 at 11:46 AM, Lukas Renggli <renggli at gmail.com> wrote:
>>
>> On 23 September 2011 11:43, Mariano Martinez Peck <marianopeck at gmail.com>
>> wrote:
>> >
>> >
>> > On Fri, Sep 23, 2011 at 11:41 AM, Mariano Martinez Peck
>> > <marianopeck at gmail.com> wrote:
>> >>
>> >>
>> >> On Thu, Sep 22, 2011 at 10:58 PM, Lukas Renggli <renggli at gmail.com>
>> >> wrote:
>> >>>
>> >>> >> > Any clues of what can be the problem ?
>> >>> >>
>> >>> >> Likely there is something messed up with the configurations.
>> >>> >>
>> >>> >> You can reinitialize all code with the following Gofer helper:
>> >>> >>
>> >>> >>     WADevelopment reinitializePackages: WADevelopment allPackages
>> >>> >>
>> >>> >> Similarly, you can see if there are any code differences:
>> >>> >>
>> >>> >>     WADevelopment localPackageChanges: WADevelopment allPackages
>> >>> >
>> >>> > That's doesn't help, because I am NOT loading seaside with
>> >>> > Metacello/Gofer/Monticello/MZC. Instead, we are experimenting with
>> >>> > Fuel
>> >>> > ;)
>> >>> > So...I am sure there must be a problem somewhere in our code, but I
>> >>> > cannot
>> >>> > understand what.
>> >>>
>> >>
>> >>>
>> >>> Sure, the two above expressions do not care how the code is loaded.
>> >>
>> >>
>> >> Are you sure?
>> >> I have a problem because the monticello packages are not present. Check
>> >> the attached screenshot.
>> >>
>> >
>> > Sorry...PharoDebug.log. And here it is.
>>
>> Ahh, maybe you should create at least MCWorkingCopies?
>>
>
> That's being dependent on how the code is loaded ;)

That depends on your definition of "the code is loaded".

I assume that the image/changes file is in *exactly* the same state as
if the code would be loaded with Monticello.

Lukas

-- 
Lukas Renggli
www.lukas-renggli.ch