"Andrew C. Greenberg" <werdna at mucow.com>  asked...

>I seem to be unable to upgrade the most current published version of Squeak 3.2 to 3.3.  Am I missing something?

Yes.

>	1. Take a raw 3.2 image
>	2. DoIt:  "SqueakVersion setImage"
>	3. Help -> updates
>
>This loads a few updates, but then stops on or about update 4681.
>
>Please advise where I am missing the boat, or what I should do to effect the update to current alpha using the updaters.

A choice was offered, at update #4653, to advance to 3.3 and the maintainer of the 3.2 fork chose NO.  There are no provisions for advancing to 3.3 after that point.

It's true that this differs from most earlier releases, because 3.2 continued to evolve after the fork, rather than merely receiving a few fixes that might have allowed for later advancing to 3.3.

It is conceivable that you could fool your system into thinking that it was at update 4653 (remove or rename all changeSets after this #), *then* change your version and go forward from there, but I have no certainty that it would be successful.

Hope this helps.

	- Dan