Thanks John,

I thought it was some of that UNIX stuff. Now if I could just understand it.
:-) I've listed my ifconfig -a below if that helps narrow it down. The only
other network interface seems to be Airport which is turned off. Any
suggestions? Or is it just broken?

Cheers,
Bob

arning-dsl-209:~ bob$ ifconfig -a
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet 127.0.0.1 netmask 0xff000000 
        inet6 ::1 prefixlen 128 
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1 
gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
stf0: flags=0<> mtu 1280
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet6 fe80::216:cbff:fe8e:b7d%en0 prefixlen 64 scopeid 0x4 
        inet 209.143.91.34 netmask 0xfffffff8 broadcast 209.143.91.39
        ether 00:16:cb:8e:0b:7d 
        media: autoselect (10baseT/UTP <half-duplex>) status: active
        supported media: autoselect 10baseT/UTP <half-duplex> 10baseT/UTP
<full-duplex> 10baseT/UTP <full-duplex,hw-loopback> 10baseT/UTP
<full-duplex,flow-control> 100baseTX <half-duplex> 100baseTX <full-duplex>
100baseTX <full-duplex,hw-loopback> 100baseTX <full-duplex,flow-control>
1000baseT <full-duplex> 1000baseT <full-duplex,hw-loopback> 1000baseT
<full-duplex,flow-control> none
en1: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        ether 00:16:cb:b3:01:ad 
        media: autoselect (<unknown type>) status: inactive
        supported media: autoselect
wlt1: flags=41<UP,RUNNING> mtu 1500
fw0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 2030
        lladdr 00:16:cb:ff:fe:e7:ff:3a 
        media: autoselect <full-duplex> status: inactive
        supported media: autoselect <full-duplex>

-- 
View this message in context: http://www.nabble.com/localHostAddress-tf4581383.html#a13078560
Sent from the Squeak - Dev mailing list archive at Nabble.com.