I have noticed that certain buttons in OmniBrowser under Squeak4.2+ 
don't work when clicked while the buttons work when the same 
OmniBrowser-based application is running in Pharo... I'm seeing this 
with the MetacelloBrowser ...

Anyway, I have gotten the impression, that someone has done some fairly 
recent work on getting OmniBrowser to work (again?) in Squeak4.x but 
haven't gotten around to tracking it down ... but then I don't even know 
if that work would address the problem:)

Dale

On 04/19/2011 07:34 AM, Hannes Hirzel wrote:
> Hi
>
> As Enrico mentioned that Pier does not load anymore in Squeak I did a
> test if Seaside loads and runs.
>
> I could load Seaside into Squeak4.3-11321 (as of today) with the
> script taken from 'Extending the System'
>
> "Seaside 3.0 http://www.seaside.st"
> (Installer ss project: 'MetacelloRepository') install:
> 'ConfigurationOfSeaside30'.
> (Smalltalk at: #ConfigurationOfSeaside30) load.
> (Smalltalk at: #WAPharoServerAdaptorBrowser) open.
>
> I run all the test of the category
>    Seaside-Tests
>
> 834 of 834 run and passed
>
>
> However I cannot start an adaptor
>
> menu 'Apps' / 'Seaside control panel'
>
> add 'Adaptor' , e.g. WAComanceAdaptor
>
> clicking on the 'start' button has no effect.
>
> The feedback still says 'stopped'
>
> Any suggestions how to proceed?
>
> Thank you for the answer in advance
>
> --Hannes
>