--- On Sun, 9/27/09, Jerome Peace peace_the_dreamer@yahoo.com wrote:
From: Jerome Peace peace_the_dreamer@yahoo.com Subject: Placing new parts in Supplies To: etoys-dev@squeakland.org Date: Sunday, September 27, 2009, 7:10 PM Hi Subbu,
To add a morph to a bin just drag and drop it onto the bin.
This is a little tricky with etoys but I have found that 1)have the object at hand 2)open the bin 3)grab the object (use halo's if necessary) 4)drag it over the bin and drop This will give you a thumbnail in the bin that works like anything else. The tricky, frustrating thing is the bin will have a tendency to close if not treated correctly while moving the cursor. Practice and skill can overcome this.
Halos around bin buttons can be used to remove them from the bin. I don't know what etoys policy is on reseting the bin contents. My experience with squeak is that bin contents are preserved unless there is some manual intervention. So saving an image should keep the new button in the bin when you restart.
Yours in curiosity and service, --Jerome Peace